My 1993 RX7 FD Build

1993 Mazda RX7 Burnout Body Kit
Restored from the ground up, my 93 RX7 pushes 500+ hp to the wheels and sits on Work Emotion XD9 wheels with a Burnout body kit.

I purchased my 1993 Mazda RX-7 in 2007 and have been restoring it ever since. The car was near death and bought very cheap, but had a clear title. The car sat in an Indiana backyard for about 6 years and rusted out the entire thing. To top it off, the owner was a teenager who tried to install an Ebay single turbo, and had it installed upside down so it blew up the engine pretty quickly, as of today there is little on the car that has not been replaced or refurbished.

All the work was done by JR Fabrications in Port Saint Lucie, FL. You can contact him at:
Jr Fabrication & Performance
1718 Southwest Biltmore Street, Port St. Lucie, FL 34984
(772) 343-0510 ‎

Here are pictures of the car from the first day I got it:

RX7 Rusted out before restoration

RX7Before restoration

FD RX7 Rear Rusted out before restoration

FD RX7 Rusted out engine before restoration

MAJOR Rust found on the undercarriage!
FD RX7 Rusted out underbody
FD RX7 Rusted out underbody

First thing done was clearing out the engine bay, then strip and paint:
FD RX7 Engine bay stripped and painted

Next up was ordering a new large streetport 13b engine from Rotary Resurrection, A T04R garrett turbo and manifold kit, a lightly used JDM transmission, ported UIM, ported LIM, ported throttle body

Garrett T04 Turbo
New single turbo for my rebuilt streetported 13b
RX7 Single Turbo Downpipe
New downpipe for my RX7 restoration
RX7 Chrome Alternator
New Alternator
RX7 Ported Throttle Body
Throttle body is ported to allow more air flow
RX7 Ported UIM
Porting the UIM and LIM will increase airflow and horsepower
13B Streetport Rotary Engine
Here’s the short block being built up
Magnecore Wires
RX7 13B with Magnecore Spark Plug wires and NGK Spark plugs
RX7 Lower Intake Manifold
Showing Lower intake Manifold
RX7 13B Short Block
Finished short block
Aeromotive Fuel Pressure Regulator
This Aeromotive A1000 fuel pressure regulator will control the upgraded fuel system
T04R Turbo on RX7
Here we have the T04R turbo and Manifold connected
13B RX7 Longblock
Our 13B longblock is finished and ready to drop in the car

More details to follow, here’s some pics of the build:

rx7-work-xd9-emotion-wheels

rx7-work-emotion-wheels-xd9-black

rx7-with-work-emotion-xd9-wheels

rx7-undercarriage-nearly-restored

rx7-wide-tires-295

rx7-underbody-restored

rx7-tial-wastegate-turbo-manifold

rx7-testfit-burnout-body-kit

rx7-testfit-burnout-front-clip

rx7-street-tuning

Leave a Reply

Your email address will not be published. Required fields are marked *